Before assembly begins, be sure to test whether all electrical appliances are functioning properly, otherwise rework is required after construction is found to be defective. All installations need to be done with power outages.
- First put aluminum foil on the left, right and rear thermostat panels
- Install the left, right and rear thermostat panels on the bottom panel
- Install the front lower panelt
- Install the heating wire: The heating wire surrounds the lower bottom panel, and the wire of the heating wire is led out of the thermostat and connected to the temperature controller. The temperature measuring probe of the temperature controller is led back to the thermostat and fixed with tape at the middle height of the temperature box (when the heating or LED fill light is turned on, the temperature on the top is high and the temperature on the bottom is low, and the average temperature at the medium height is taken)
- Lay aluminum foil on the bottom surface, pay attention to stick it on the front, rear, left and right panels to prevent water overflow or condensate water from flowing out of the thermostat in winter
- Install the front upper panel (be careful not to break the switch wire connected to the upper panel), and install the glass between the upper and lower front panels before tightening the screws. If the glass sliding door is installed after the upper and lower panels are done, the glass sliding door may not be properly installed between the two front panels.
- Surroundthe LED strip along the front upper, back, left and right panels and fix it (be careful not to exceed the thermostat, otherwise the upper panel cannot be installed in the correct position), and lead the LED strip wire out of the thermostat.
- Install the upper panel
- Install the internal heating fan and light socket adapter for the subsequent expansion requirements (if you need). Be sure to prevent any direct water spray on the adapter.
- Let your plants live in our your thermostate happily.
